Water Damage Restoration – The Facts? It is the process of repairing a house or property to its pre loss condition. Damage to the home could be due to an overflow, flood or any other water damage event. The water damage restoration process involves several key procedures like loss assessment, categorization based on the water contamination levels, decontaminating and drying the structure, monitoring of the process and completion of the process. The two main large certifying bodies, namely the IICRC (Institute of Inspection, Cleaning and Restoration Certification) as well as the RIA (Restoration Industry Association) that recommends standards for water damage restoration. The S500 damage due to water guide is the benchmark tool that is utilized by companies specializing in restoration of water damage.
Loss Assessment and Categorization – Loss evaluation is the foremost and the most important part of water damage restoration. The assessment must be correct in order that a suitable response can be utilized. In restorating the harm due to water, technicians and the insurance providers must work together and know what is damaged and how to make restoring the injury. Identifying the cause of the damage, documentation of damage, and accurate estimates are mandatory for any proper water damage and mold restoration. Categorization is based on the contamination amounts of the water source. The categories are highlighted below
Category 1 – This can be water from clean sources like pipes, sinks and toilets without faeces or urine.
Category 2 – This really is water which has some contaminants like water from the dishwasher, washer or toilet with urine.
Category 3 – This can be water that is certainly highly unsanitary and is capable of doing causing illness or death if ingested. Sewage water, water from toilet with faeces, standing water with microbial growth and floodwater are some examples.
Decontamination and Drying – After the evaluation is done, the whole process of drying and decontaminating begins in the site. Based on the extent of damage, damage caused because of water can be classified into 4 types. Class 1 Damage- When loss is fixed to a small area and less water has been absorbed by materials. This brings about slow evaporation rate. Class 2 Damage – Once the damage is always to the whole room and carpet area. Class 3 Damage – When the entire area is saturated with water and Class 4 Damage – when there are many deep saturation pockets. Decontamination and drying is a key stage in Water damage and mold restoration and equipments like blowers, dehumidifiers, scrubbers and subfloor drying equipments must be used. Decontamination has to be done if contamination has become detected in the area. Decontamination may be done for the entire area or even in specific pockets where contamination continues to be detected.
Monitoring and Completion – Monitoring the restoration procedure of damage caused as a result of damage is critical to get the desired results. One has to be proactive throughout the monitoring process. Checking if the drying tools are setup properly, assessing if the personnel involved are qualified for the task and checking when the equipments will be in working order inwtsy all portion of the monitoring process. Necessary steps should be taken if anything wrong is spotted throughout the monitoring process. The whole procedure of water damage and mold restoration could be classified as complete just once humidity, temperature and also the moisture content is just as per industry standards. Upon completing the water damage restoration process, the drying equipment can be removed.